Jump to content
Mark A

active V4.5 HF2: OpenLC EUR and NA - night lighting issue

Recommended Posts

Posted (edited)

Hi all,

 

I can't shake this feeling that my night lighting in the above regions is not as it should be.

The thread below gives a good indication of what I''m seeing - basically highways only and no other lights. Unfortunately this guys solution was a complete un/re-install of P3D, which I'd very much like to avoid if this is merely a layering problem.

 

 

I'm running Global BASE and VECTOR, plus the OPEN LC products above. Also have NZNI, NZSI, and AU v2 along with a range of airports in those full-fat regions.

 

No 'full-fat' regions in North America or Europe, but a couple of airports. EGE and TEX in NA and INN in EUR. All installed within the prepar3d folder except for Orbx objectflow which for some reason is in an Orbx library.

 

The Scenery.cfg file from my programdata folder attached in case layering is an issue.

 

OLC_NA_LIGHTS folder has 259 files, all BGL extension, and prefixed with an ! symbol.

OLC_EU_LIGHTS has 804 files, again all BGL and prefixed with the ! symbol.

 

Hoping someone can guide me in further investigation.

 

Many thanks!

 

scenery.cfg

Edited by Mark A

Share this post


Link to post
Share on other sites

Hello,

there is a question raised internally on this subject and it is being looked into.

Share this post


Link to post
Share on other sites
On 7/14/2020 at 12:57 AM, Nick Cooper said:

Hello,

there is a question raised internally on this subject and it is being looked into.

Is it a conflict with other Autogen addons running like Justsim and Gayasim?

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...