Jump to content
  • 0

ChasePlane No Launch after Migration


Question

Followed the required steps for migration setup, launched CP from Orbx and nothing happens.  Uninstalled, rebooted, and tried again--same result.  Any suggestions would be appreciated--Thanks

Link to post
Share on other sites

14 answers to this question

Recommended Posts

  • 0

I posted this in the other thread - worked for me - 

 

  • I solved my issue - in my ...\AppData\Roaming\Lockheed Martin\Prepar3D v5 folder I was missing simconnect.xml.  I copied it over from my v4 folder and now it seems to run fine.  Hope it helps . . .
Link to post
Share on other sites
  • 0

Thanks--I was using Prepar3D v4.5 and I don't have simconnect.xml in the appdata… directory.

Checked again administrative rights. The event log lists a faulting module "d3d9.dll"; the graphics drivers are to update

Link to post
Share on other sites
  • 0

Update--Apparently the issue is the "immersive updater."  If I delete in the local tmp directory,  the folder "85b75v4b...."  and open CP, everything is OK.  If within CP I attempt to download the update, I'm in the same loop as described above.   It's the download of the update that's the problem--I appreciate your comments and assistance--

Link to post
Share on other sites
  • 0

I have just converted from the old VFX system to Orbx Central and same issue ... Chaseplane will not launch.

 

I should add I am still using P3Dv4

 

Fixed it! Nothing to see here! :D

Edited by Buzz71
Resolved issue
Link to post
Share on other sites
  • 0

Hi,

 

I had similar problems having migrated my account from Old Prop to Orbx yesterday.

After I followed the instructions to uninstall Chaseplane (CP), then Vfx Central then re-install from Orbx Central, CP would not appear when starting up P3Dv4.5

 

I did the following to make it work:

 

1. Ensure P3Dv4 is not running. Go to CP from your Start menu. Run CP from there and let it configure. Note it did not configure as part of the installation from Orbx Central.

2. I found that when starting P3Dv4.5 CP did start up automatically, was placed in a CP view but I still could not access the CP menus. It kept prompting me to configure CP again.

3: Shutdown P3Dv4.5 again and re-ran CP from the Start menu. At this point it re-ran the config but it ran all the way through. Some additional steps of the config appeared to run.

4: Rebooted PC and restarted P3Dv4.5 and everything was installed, configured and could access my old saved views.

 

Hope this helps,

Mark

Link to post
Share on other sites
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...