Jump to content

Recommended Posts

Here is the final batch of three airports with provisional updates for inclusion in AUv2. These are not final but will address most of the issues when run in AUv2. The work required to sort the few remaining issues is complex and will take some time to finish so it is suggested you use these updates in the meantime.

 

Please follow the guidelines included in the first post above for installation. 

 

YBRM Broome International

 

This update will remove duplicate buildings at the airport. Still to be resolved is some of the 'lumpy' terrain in the town and outer suburban areas. These terrain issues are well outside the airport precinct so should not spoil your simming experience at YBRM Broome.

 

There are no file swaps for this update and so no Control Panel adjustment is required. Just copy the following file into your Orbx\FTX_AU\FTXAA_YBRM\scenery folder overwriting the existing one and you're good to go. This file is good for all versions of P3D and FSX.

 

Orbx_APX_YBRM.bgl

 

 

YBCG Gold Coast.

 

As with Broome, this update will only resolve the most noticeable issues at YBCG but should still enable you to enjoy the airport for the most part. YSPT Southport is completely resolved with this update. Duplicate buildings and scenery items from the AUv2 version of both YBCG and YSPT has been fixed.

 

This update will not work with YBCG installed in P3D V4 via XML Add-On with Orbx Central but will be fine for other sims installed via Orbx Central and all installs via the old FTXC 3. An update via Orbx Central should be available in the next few days.

 

YBCG_Gold_Coast.zip

 

 

YMEN Essendon.

 

The undulating country side and the detail motorway running along two sides has posed a problem with this airport which will take some time to resolve. To enable you to enjoy the airport in the meantime, I've flattened the motorway and lowered the overpasses to eliminate most of the terrain issues. This is not a permanent change and will be sorted properly with a future update. 

 

Again, this one will not work with YMEN installed in P3D V4 via XML Add-On with Orbx Central but will be fine for other sims installed via Orbx Central and all installs via the old FTXC 3. An update via Orbx Central should be available in the next few days.

 

YMEN_Essendon.zip

 

 

 

  • Like 1
  • Thanks 2

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...