tonyc1946 3 Posted October 3, 2016 Share Posted October 3, 2016 I have suddenly developed floating objects on all my Norway airports ranging from floating clocks to floating ventilation stacks! I have Airports of Norway and tried it with AON switched on and off. Makes no difference. Any ideas gratefully received as always! Link to post Share on other sites
Richard Lincoln 762 Posted October 6, 2016 Share Posted October 6, 2016 Hello Tonyc1946, I have only found this magical event in FSX, I am not sure why it happens, exiting out of the sim and firing it back up again seems to do the trick. Please report back if this has worked for you. Link to post Share on other sites
Ken Terry 577 Posted October 6, 2016 Share Posted October 6, 2016 Tony, check your mesh resolution try 5 mts. Regards Ken 1 Link to post Share on other sites
tonyc1946 3 Posted October 10, 2016 Author Share Posted October 10, 2016 Richard and Ken Thank you for your replies. I have been busy so no time to fire up FSX until now. Unfortunately the floating objects are still there! I have the mesh resolution at 1m so no problems there. I clearly have something corrupt in one of the sceneries. My question is can you possibly confirm if the clock, air vents and so on are objects from FTX or AON? I did notice that at one airport that the satellite dish and cage were actually part of a high lift vehicle used perhaps for deicing or something? All very strange! But if I can know which of the programmes these come from I can delete and reinstall perhaps. Again thank you for all your help it is greatly appreciated. Tony Link to post Share on other sites
Jan Nordberg 3 Posted October 10, 2016 Share Posted October 10, 2016 Think I know AON quite good, so I will say they are part of FTX. Andrew and I will never use that object showing up in picture 2. Where did you take those pictures, just so I can check if I can have the same problem. Link to post Share on other sites
Ticker7 62 Posted October 10, 2016 Share Posted October 10, 2016 Quote : I have the mesh resolution at 1m so no problems there. Hi Tonyc, if you read the post from Ken Terry he stated to try your mesh at 5 not 1 which is a probable cause of the problem, most if not all ORBX scenery is run at 5 and is fine at this resolution so I would give it a go and see what happens it's worth a try mate. Link to post Share on other sites
tonyc1946 3 Posted October 11, 2016 Author Share Posted October 11, 2016 23 hours ago, Ticker7 said: Quote : I have the mesh resolution at 1m so no problems there. Hi Tonyc, if you read the post from Ken Terry he stated to try your mesh at 5 not 1 which is a probable cause of the problem, most if not all ORBX scenery is run at 5 and is fine at this resolution so I would give it a go and see what happens it's worth a try mate. Thanks guys! Bingo! It was the Mesh Resolution needed to be 5m. NOW I know what that clock sits on! Thanks everyone for your time and help! Tony Link to post Share on other sites
Recommended Posts